Module type: |
Purpose: |
Controller type: |
8
output |
Allows any 8 devices rated
at 12 volts and less than 0.5 amps to be switched on and off |
8
output
or
Remote 8 output |
8
input |
Allows any 8 sensors
(switches, optical or magnetic) to be monitored and their state to be shown on LEDs |
8
input |
Motor |
Allows a 12 volt d.c. motor
rated at up to 1 amp to be run at any speed (up to the motor's maximum) and in either
direction |
Motor |
Servo |
Allows the position of a
standard radio control type servo to be set |
Servo |
CD
points |
Allows solenoid type points
motors to be operated. One controller will operate two modules |
Dual points
or
Remote dual points
or
Remote quad points
|
| Motorised points |
Allows motor driven points
motors (often known as 'slow motion' type) to be operated. Can also be used to operate
signals, barriers etc. which are driven by a motor between two extreme positions. One
controller will operate two modules |
Dual points
or
Remote dual points
or
Remote quad points |
| Signal/Barrier |
Uses a standard radio control
type servo to operate barriers or signals in a realistic manner. The barriers or signal
start lifting slowly, then lift and stop at the top with a slight bounce. They descend
more rapidly with a greater bounce at the bottom of travel. Two overall speeds are
selectable, a faster one for signals and a slower for barriers. |
Dual points
or
Remote dual points
or
Remote quad points |
CD points
or
Motorised points
and
8 output |
Allows automatic control of a
fiddle yard with up to 8 tracks (7 points). A single switch press will sequence the points
motors to route to a track. An output module can then (optionally) automatically indicate
the selected track or, through relays, apply power to the selected track. |
Fiddle yard |
